Installation Instructions

APPLICATION #1

Truss-T Hanger Mounted to Top or Bottom Chord of Truss System using Integrated Nut/Washer

1. Remove Truss-T Hanger and square nut /washer from packaging.
2. Using your hands, thread the square nut/washer (clockwise) to provide a 2-1/2” clearance between the bottom of the “T” and the top of the washer.
3. Rotate the Truss-T Hanger Assembly 90° clockwise while insuring the bottom of the Truss-T Hanger “T” is above the top surface of the steel truss.
4. Position the Truss-T Hanger Assembly in the proper location and hand tighten.
5. Once installed, tighten the nut with a wrench.

---

APPLICATION #2

Support Luminaire/Conduit, Tubing & Cable/Piping with 1/2” NPT Threaded Coupler Top or Bottom Chord

1. Remove Truss-T Hanger unit from packaging.
2. Engage coupling to provide a 2-1/2” clearance between the bottom of the “T” and the top of the coupling.
3. Precut a section of 1/2” Schedule 80 pipe to the required length for the application.
4. Thread the pipe section into the coupling while maintaining the 2-1/2” distance outlined in Step 2.
5. While holding on to the pipe section, insert the Truss-T Hanger Assembly parallel through the center of the steel truss.
6. Rotate the Truss-T Hanger assembly 90° clockwise while insuring the bottom of the Truss-T Hanger “T” is above the top surface of the steel truss.
7. Position the Truss-T Hanger Assembly in the proper location and hand tighten.
8. Once installed, the Truss-T Hanger Assembly may be repositioned by loosening the assembly and then hand tightening securely.